高圧ドレン回収を行う場合、ボイラ付属の液面電極棒以外の信号系で給水ポン

高圧ドレン回収を行う場合、ボイラ付属の液面電極棒以外の信号系で給水ポンプが発停する為、ボイ
ラ付属の液面電極棒の信号変化がないことによりＥ３５停止となることがあります。従って、この様
な場合やユーザ事情（設備不良等）により止む得ずＥ３５の機能をなくしたい場合に本スイッチをＯ
Ｎにすると、Ｅ３５の機能はなくなりＥ３５は出なくなります。

Results (English) 1:

Water pump from stop in the signal system of the boiler comes with liquid electrode Rod other than if you do high pressure drain recovery for the BOILa may not included liquid electrode Rod signals change that makes it E35 stop. Thus, like thisWith this switch o or if want to eliminate the E35 features stopping due to user （ poor facilities, etc. ）E35 features will no longer be N, and the E35 will not appear.

Results (English) 2:

When performing a high drain recovery, because of the coupling feed water pump in the boiler supplied liquid surface electrode rod than the signal system, voice
may become an E35 stopped by the lack of signal change La supplied liquid surface electrode rod. Therefore, this way
this switch if you want to eliminate the function of the resulting not E35 stop by a case or user circumstances (equipment failure, etc.) O
When the N, E35 is no longer function of E35 will no longer appear.

Results (English) 3:

When the high pressure drain recovery boiler, but comes with a liquid level electrode signal system to stop water supply pump, there is no change in the signal of the boiler liquid level electrode is attached at the La E 35 is stopped. Therefore, when a user of such circumstances and poor (equipment) if you want to lose the function of E 35 unavoidably in O N at present, the function of the switch 35 is not E E 35 up, not down.